Products

TintoDeparaffinator Hot Rinse 20X

SKU: edd2b8c3e7a2 Category:

Ancillaries

For IVD Use
For Research Use Only
Safety Data Sheet

SDS

Intended Use For In Vitro Diagnostic Use
Summary and Explanation The TintoDeparaffinator Hot Rinse is part of a set of solutions intended for paraffin removal from paraffin-embedded tissues, hydrating and heat permeabilizing tissues to achieve epitope or nucleic acid retrieval. The TintoDeparaffinator Hot Rinse, TintoDeparaffinator Citrate (BSB 0175 and BSB 0176) and TintoDeparaffinator EDTA (BSB 0177 and BSB 0178), are innovative reagents formulated to reduce exposure to toxic solvents and to reduce the number of steps in deparaffinization, hydration and epitope or nucleic acid retrieval, thus making them a safe and efficient alternative to traditional deparaffinization involving xylenes and alcohols. Since they do not interfere with the detection of proteins by Immunohistochemistry, Immunocytochemistry, or of nucleic acids by CISH and FISH, results are the same as when using xylene and alcohol.

The deparaffinization procedure with TintoDeparaffinator Hot Rinse, TintoDeparaffinator Citrate, and TintoDeparaffinator EDTA solutions uses a heat-assisted deparaffinization method while achieving tissue hydration and retrieval of proteins and nucleic acids. Deparaffinization at moderately elevated temperatures has been shown to adequately dissolve paraffin at significantly lower solvent concentrations compared to methods of deparaffinization at ambient temperatures using xylenes and/or xylene substitutes. By utilizing lower non-toxic solvent concentrations, the process of tissue rehydration following deparaffinization and retrieval can be achieved with a single final rinse step to remove micro paraffin leftovers, followed by direct transfer of slides to a buffer bath. These reagents are specifically designed to work with the Bio SB TintoRetriever Pressure Cooker (BSB 7008) or TintoRetriever PT Module (BSB 7030 and BSB 7033) but may be used with any heating device that provides the required temperature.

These reagents are designed to deparaffinize, rehydrate and retrieve one microscope slide containing a standard size (from 0.5cm x 1cm up to 2.5cm x 2.5cm diameter) paraffin-embedded tissue section per 3 ml of TintoDeparaffinator Hot Rinse 1X.  A typical staining dish containing 200-250 ml of the TintoDeparaffinator Hot Rinse 1X solution will help deparaffinize approximately 72 standard tissue sections.  If larger tissue sections are used, the number of processed slides may be less.  If residual paraffin is observed microscopically on the slides following deparaffinization, the deparaffinization reagents should be replaced.

TintoDeparaffinator Hot Rinse is intended to be used as a final rinse step in order to help remove residual micro-paraffin leftover on the slides after the use of heat treatment with either the TintoDeparaffinator Citrate or the TintoDeparaffinator EDTA.

ChromoProtector is highly recommended to be used after the intended staining procedure in order to remove any significant micro-paraffin that may be leftover before mounting slide with a coverslip.

Presentation TintoDeparaffinator Hot Rinse 20X contain glycols and glycol ethers.  It is provided in liquid form.
Availability
CAT.# Concentration VOL
BSB 0179 TintoDeparaffinator Hot Rinse 20X 100.0 ml
BSB 0180 TintoDeparaffinator Hot Rinse 20X 1.0 L

Related products

Skip to content